Expert Answers about RV Trim
- Does The Furrion Solo RV Microwave Have Mounting Holes For A Trim Kit
- The Furrion Solo RV Microwave # FMSN09BL does not have mounting holes for a trim kit. You would need to mount the trim kit to the cabinet/wall around the microwave.
view full answer... - Is There a Warranty for the Camco RV Vinyl Trim Insert # CAM25262
- Yes, the Camco RV Vinyl Trim Insert # CAM25262 that you referenced comes with a 1-year limited warranty.
It does have UV inhibitors to resist the damage that the sun can inflict upon outdoor equipment so that it will last longer and keep your RV or truck camper looking good!
view full answer... - Vent for Greystone Standard RV Microwave w/ Trim Kit
- The Greystone Standard RV Microwave w/ Trim Kit, # 324-000105 does have a front vent. The trim kit fits around the microwave to dress it out. Please note the linked product review video below where Jeff points this out.
view full answer... - Is Camco RV Vinyl Trim Insert CAM25272 Flexible
- Yes, the slight bends or edges are vinyl and are indeed flexible for the Camco RV Vinyl Trim Insert - Black - 100' Long x 3/4" Wide # CAM25272.
view full answer... - Will The Plastic Trim Kit For The Furrion Standard Microwave Melt If It Is Installed Over The Range
- Yes, the Trim Kit for Furrion Standard Microwave - Black # FMSM09BLTK and the Furrion Standard RV Microwave - 1,350 Watts - 0.9 Cu Ft - Black # FMSN09BL will be safe from melting.
These two items were designed to be able to install in cabinets on countertops or over the range.
Most common hard plastics can hold and withstand heats up to and exceeding 212°F. So as long as you mount the unit in a normal or standard place over the range and give it ample venting space it will be just fine.
view full answer... - Is Gustafson RV Puck Light A Replacement For 3-Inch RV Lights With Gold Trim Ring
- The Gustafson RV Puck Light, part # 277-000342 is mounted directly to a surface by using the three mounting holes in the base of the light. The mounting hardware is included.
These lights measure 3-5/8 inches diameter overall and are 3/4-inch tall. These lights have 12 LEDs. They do not use the gold ring you mentioned for mounting.
view full answer... - Is The Furrion Standard RB Microwave Able To Be Mounted Over The Range
- The microwave in the photo looks like a Greystone Standard RV Microwave w/ Trim Kit - 1,350 Watts - 0.9 Cu Ft - Black # 324-000105.
And Yes the Furrion Standard RV Microwave - 1,350 Watts - 0.9 Cu Ft - Black # FMSN09BL can be mounted over the range.
view full answer... - Satin Nickel wall light
- You can both reduce power draw and increase usable light output by changing out your old lights to LED lighting. I would suggest the Gustafson RV LED Sidewall Light w/ Button - Satin Nickel - White Shade w/ Silver Trim
Item # 277-000464.
view full answer... - How Do The Steps Work With The Solera Family Room Skirting On The Camper?
- When you install the camper side panel of the Solera Family Room # LC362230 you will be trimming out an opening for the steps to pass through.
I have attached a link to the installation instructions below but here is a picture for you to understand what it will look like.
A set of MORryde StepAbove RV Steps # MR68RR are a great way to have steps without having to worry about cutting the panel. These type of steps fold up inside the door and as the legs go all the way to the ground the...
view full answer... - Can You Trim Off Some Of The Lower Bend On The Stromberg Carlson RV Ladder To Fit A Motorhome Bumper
- You could cut off the two inches that you need from the lower bend on the # LA-401BA but you would need to find a way to crimp the end of the pipes to hold onto the mounting bracket. The ends of the pipes are simply rolled outwards to prevent the bracket from falling off. Most likely your local hardware store will carry some sort of pipe end shaping tool for you to accomplish this.
view full answer... - Do I Need To Replace My RV Ladder Or Just Repair It After Hit By A Tree
- Yeah those trees really hate ladders and AC units let me tell you.
If the ladder or any part of it was bent I recommend replacing it on the grounds of safety issues.
Once aluminum is bent it looses a large amount of structural integrity. No one needs to fall off their RV while climbing the ladder to the roof.
We have the Stromberg Carlson RV Exterior Ladder w/ Hinges - Aluminum - 99-1/2" T x 12" W - Black
# LA-401BA. This comes with all the hardware you need to replace the old unit.
We...
view full answer... - Installation of a Front Mount Hitch on a 2013 Ford E-450 Lazy Daze RV
- I have attached a link to the installation instructions of the Draw-Tite Front Mount Hitch, # 65053, for you to check out. There will be some fascia trimming required to install this hitch on your 2013 Lazy Daze RV, but this is detailed in the installation instructions as well.
The cautions that you have seen are valid. The air flow through the front grille is very important to cool the engine and prevent overheating. If items such as bikes or other cargo are blocking the airflow, you...
view full answer... - Installation of TorkLift GlowStep Revolution Scissor Steps on 5 the Wheel
- The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, # TLA8004 can be used on a 5th wheel same as on a travel trailer. The part number you linked to # TLA8004 is for an entry height of 32-1/2" to 44". If I follow your statement correctly on your concerns with installation, it sounds like the Lippert Outriggers for RV Steps, # LC301704 may be what is needed.
view full answer... - How To Measure For a Replacement Roof Vent?
- If you are looking to replace an entire vent assembly the most common cut out dimensions are 14-1/4" x 14-1/4". As to not disturb the roof sealant you can remove the inner garnish on the vent from inside your 2018 Forest River Sunseeker. You will be able to see the opening with the garnish trim removed. You will also want to determine the thickness of your ceiling to ensure if the new vent includes a new garnish that it is tall enough to fit your Sunseeker.
I have linked an article below...
view full answer... - Why Is It Not Recommended To Step Up to 8,000LB Leaf Springs Instead of 7,000LB Leaf Springs?
- We do not recommend moving from 7,000lb # e64SR to 8,000lb # DX74XR leaf springs as this creates a stiffer ride with more bounce. This causes more shock to transfer inside your RV which can cause damage to the trim and electronics. Instead I recommend adding the SumoSprings # SS26MV for overslung axles or # SS33HR for underslung axles. These help to absorb shock from transferring in your trailer as well as give you more support to reduce sag in the leaf springs.
Also adding heavier leaf...
view full answer... - Options for Carrying a 900 lb Motorcycle with a Motorcycle Carrier on a Motor Home
- The first step that you will want to take before attempting to carry your motorcycle is to contact the manufacturer of your motor home to determine tongue weight capacity of the motor home. The tongue weight capacity of your motor home must exceed the weight of your motorcycle and lift combined. Most motor homes do not have very high tongue weight or towing capacities.
If you find that your motor home can support the weight of your bike plus the weight of the lift, you will need to determine...
view full answer... - 5th Wheel Towing with 2018 Toyota Tundra Double Cab
- From the online specs available to me the 2018 Toyota Tundra Double Cab has a max towing capacity of 6,400 to 10,200 lbs. We always recommend that you consult your vehicle specific owners manual for towing specs as each models trim specs, engine option and gearing all influence the vehicle capability.
You do not state what bed length you have but if you have the 6-1/2' bed you will most likely need a slider type hitch. I suggest the B&W Patriot 5th Wheel Trailer Hitch w/ Slider, # BWRVK3270...
view full answer... - Does the Ventline Ventadome Metal Trailer Roof Vent # V2110SP-24 Carry a Temperature Rating
- You ask an interesting question.
Trailer roof vents like the referenced Ventline Ventadome Metal Trailer Roof Vent # V2110SP-24 do not carry a formal temperature rating. This is because these passive vents are intended only to vent heat in a trailer generated from the environment: sun and outside air. They are not really intended for an application like yours where a heat-generating item will be operated inside the trailer.
Although the lid and mounting flange on # V2110SP-24 are metal,...
view full answer...
Go To Results